TACT  SWITCH  SPECIFICATION( 轻 触 开 关 说 明 书 )

6.3 Environmental 环境

Item 项 目

Test Condition试验条件

Requirements 要求

6.3.1.

Resistance to Low Temperatures

耐低温

Following the test set forth below the sample shall be left in mormal temperature and humidity conditions for one hour before measurements are made:

样品按下列条件进行耐低温试验，测试前在正常温度和湿度条例上放置 1 小时

(1) Temperature: -30±2℃      温度

(2) Time: 96 hours               时间

(3) Water drops shall be removed   擦除水珠

Item 6.1

Item6.2.1

Item6.2.2

6.3.2.

Heat Resistance

耐 热

Following the test set forth below the sample shall be left in normal temperature and humidity conditions for one hour before measurements are made: 样品按下列条件进行耐热试验，测试前在正常温度和湿度条件下放置 1 小时

(1) Temperature:240±5℃      温度

(2)        Time: 96 hours      时间

Item 6.1

Item6.2.1

Item6.2.2

6.3.3.

Moisture

Resistance

耐潮湿

Following the test set forth below the sample shall be left in normal temperature and humidity conditions for one hour before measurements are made: 样品按下列条件进行耐潮湿试验，测试前在正常温度和湿度条件下放置 1 小时

(1)       Temperature: 60±2℃      温度

(2) Relative humidity: 90 to 95%    相对湿度

(3)              Time: 96 hours      时间

(4) Water drops shall be removed   擦除水珠

Item 6.1

Item6.2.1

Item6.2.2

6.3.4.

Temperature

Cycling

温度循环

www.km5858.com

Following the test set forth below the sample shall be left in normal temperature and humidity conditions for one hour before measurements are made. 样品按下列条件进行温度循环试验，测试前在正常温度和湿度条件下放置 1 小时

During this test, water drops shall be removed,

在试验期间，擦除水珠。

Item 6.1

Item6.2.1

Item6.2.2

APPD

CHKD

DSGD

PARTNO:        

5/10